Tuesday, 15 November 2011

Change Autotuning, RSS, Chimney and Taskoffload Settings

To get the status of you present settings open an administrative command prompt and run:
netsh int tcp show global
netsh int ip show global

There are 4 settings that are regularly changed to tune performance for older clients, to disable them you would run the following commands:

netsh int tcp set global autotuning=disabled
netsh int tcp set global rss=disabled
netsh int tcp set global chimney=disabled
netsh int ip set global taskoffload=disabled

Finally you must reboot the appliance.

2 comments:

  1. You can now change the settings of the Rss, chimney and the Task off load from this page of the how to write a professional research paper in order to find the efficiency in your work. You can change the settings with the few and simple steps.

    ReplyDelete
  2. The administrative command can be run in this section. To run the computer in the better or efficient way is not the easy thing. You have to give the right command at the right time. You can also buy the cheap drone with camera for your best style of the life.

    ReplyDelete

Correction, question or suggestion, it's all welcome here.